Instructions for fitting motor:

Remove back plate from Nokia 3210
Remove battery and sim card.
Gently prise the metal and ceramic antenae cover from the phone by using the tip of a small screwdriver at the side, it should lift up from the bottom slightly then push it upwards.
Once removed, undo the four star screws with the appropriate tool.
Then remove metal chassis and clip the motor to the underside of the chassis housing in the special concaved space for it. The two copper strips on the bottom of the motor should rest on the copper strips on the circuit board when the chassis is replaced. ENSURE THAT THE MOTOR FACES OUTWARDS OTHERWISE A SHORT CIRCUIT MAY OCCUR.

Then put the phone back together again taking care not to damage the antennae cover again.

Turn the phone on and then follow the next steps to activate the vibrate menu:

Instructions for running software:

insert vibra motor.
then connect phone to M2BUS data cable and a computer.
run programme:
click: "read" , "visible"
"write" "reset"

Go to the tones menu in the phone. You should now have a new submenu named "vibrating alert"
Turn the vibrate menu "on" then get someone to phone you to check the motor is working.